Small products page
Example of our 1/2"x1/2" spacers. These can be used for shock spacers or as busings. $4.50pr
We stock laser cut tabs that are simple in design and can be used for what ever you can dream up. The 1/4" tabs start at $2.50ea and the 3/8" start at $3.50ea. This photo is just a small sample.
Our high/miss spacers are built form DOM steel tubing. We build them in two widths. The normal heim miss width and a wide width. The wide width allows you to remove the heim and go to a rebuildable joint or up size the heim later. $4ea to $7ea depending on heim size.
Alignment jig set for either full float or semifloat are available. Shown is the FF set with the FF jigs made from 7075. I also make them from steel. The carrier pucks and semifloat pucks are mae from 6061. Carrier pucks and semifloat pucks range from $65 to $75pr. 7075 FF jigs are $150 for 1 or $250pr. Steel FF pucks are $120 for 1 or $200pr. The jig bar is 1.5" precision ground, chromed, heat treated steel and goes for $180. A complete set with carrier pucks, 7075 FF pucks and jig bar goes for $450. Semifloat set with jig bar goes for $300.
Billet Dana 44 drive flange caps. These are O-ring sealed and made to replace the stock steel cover. $39.95pr.
D44 Drive flange caps
916-434-6978